Toyota RAV4 manuals

BMW 7 Series (G11/G12) 2015-2022 Owners Manuals: Active Cruise Control with Stop & Go function ACC- Setting the speed

BMW 7 Series (G11/G12) 2015-2022 Owners Manuals / Controls / Driver assistance systems / Active Cruise Control with Stop & Go function ACC- Setting the speed

Maintaining and storing the speed

Maintaining and storing the speed


Press the rocker switch up or down once while the system is interrupted. The system will be activated.

The current speed is maintained and stored as desired speed.

The stored speed is displayed on the speedometer.

DSC Dynamic Stability Control is switched on, if necessary.

The speed can also be stored by pressing a button.

Press the button.


Changing the speed

Changing the speed


Press the rocker switch up or down repeatedly until the desired speed is set.

If active, the displayed speed is stored and the vehicle reaches the stored speed when the road is clear.

Hold the rocker switch in position to repeat the action.

Adjusting the distance

Safety information

Warning


The system cannot serve as a substitute for the driver's personal judgment. Due to the system limits, braking can be late. There may be a risk of accident or risk of damage to property. Be aware to the traffic situation at all times. Adjust the distance to the traffic and weather conditions and maintain the prescribed safety distance, possibly by braking.

Reduce distance

Press the button repeatedly
until the desired distance is set.

Instrument cluster will display selected distance.

Increase the distance

Press the button repeatedly until
the desired distance is set.

Instrument cluster will display selected distance.

Continuing cruise control

An interrupted cruise control can be continued by calling up the stored speed.

Make sure that the difference between current speed and stored speed is not too large before calling up the stored speed. Otherwise, unintentional braking or accelerating may occur.

Press the button on the steering wheel with the system interrupted:

Without steering and traffic jam
assistant.

With steering and traffic jam
assistant.

Cruise control is continued with the stored values.

In the following cases, the stored speed value is deleted and cannot be called up again:

Active Cruise Control with Stop & Go function ACC- Overview
Buttons on the steering wheel Button /Function With steering and traffic jam assistant: Cruise control on/off. With steering and traffic jam assistant: Select function. Without steering and traffic ...

Active Cruise Control with Stop & Go function ACC- Changing between cruise control with/without distance control
Safety information Warning The system does not react to traffic driving ahead of you, but instead maintains the stored speed. There may be a risk of accident or risk of damage to property. Adjust the ...

Other materials:

Diagnosis system
Description Engine immobiliser system data and diagnostic trouble codes (dtcs) can be read through the vehicle's data link connector 3 (dlc3). In some cases, a malfunction may be occurring in the engine immobiliser system even though the security indicator light is not illuminated ...

Removal
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and ...

Vehicle identification number
Engine compartment The vehicle identification number can be found in the engine compartment, on the right-hand side of the vehicle. Windshield The vehicle identification number can also be found behind the windshield. iDrive It is also possible to display the vehicle identification number via iDr ...

В© 2011-2022 Copyright www.trav4.net