Toyota RAV4 manuals

BMW 7 Series (G11/G12) 2015-2022 Owners Manuals: Coolant

General information

Coolant consists of water and additives.

Not all commercially available additives are suitable for the vehicle. Do not mix additives of different colors. Observe the water - additive mixing ratio of 50:50. Information about suitable additives is available from a dealer's service center or another qualified service center or repair shop.

Safety information

Warning

With the engine hot and the cooling system open, coolant can escape and lead to scalding.

There is a risk of injury. Only open the cooling system with the engine cooled down.

Warning

Additives are harmful and incorrect additives can damage the engine. There is a risk of injury and risk of damage to property. Do not allow additives to come into contact with skin, eyes or articles of clothing. Use suitable additives only.

Coolant level

General information

Vehicles with gasoline engine feature two cooling circuits. Always check the coolant levels of both coolant reservoirs and refill as needed.

The coolant level is indicated using minimum and maximum markings in the filler neck of the coolant reservoir.

Depending on the engine installation, the coolant reservoir is located on the right side or the left side of the engine compartment.

Additional information: For an overview

Checking the coolant level

  1. Let the engine cool.
  2. Open the hood.

    Opening

  3. Turn the lid of the coolant reservoir slightly counterclockwise to allow any excess pressure to dissipate, then open it.
  4. Open the coolant reservoir lid.
  5. The coolant level is correct if it lies between the minimum and maximum marks in the filler neck.

Checking the coolant level


  1. Close the lid.

Adding coolant

  1. Let the engine cool.
  2. Opening the hood.

    Opening

  3. Turn the lid of the coolant reservoir slightly counterclockwise to allow any excess pressure to dissipate, then open it.
  4.  Open the coolant reservoir lid.
  5. If the coolant is low, slowly add coolant up to the specified level; do not overfill.
  6. Close the lid.
  7.  Have the cause of the coolant loss eliminated as soon as possible.

Disposal

Comply with the relevant
environmental protection regulations when disposing of coolant and coolant additives.

Engine oil- Adding engine oil
General information Only add engine oil when the message is displayed in the instrument cluster. The quantity to be added is indicated in the message shown on the Control Display. Only add suitable t ...

Washer fluid
General information All washer nozzles are supplied from one reservoir. Use a mixture of tap water and windshield washer concentrate. If desired, a windshield washer concentrate containing antifreez ...

Other materials:

Brake pedal load sensing switch
Description The brake pedal load sensing switch is turned on when the brake pedal is depressed with force exceeding a predetermined level. The skid control ecu detects if the brake pedal is depressed or not via this circuit. Wiring diagram Inspection procedure Notice: When repla ...

Removal (2005/11-2006/01)
Remove front wheel Drain automatic transaxle fluid Drain the automatic transaxle fluid for u140f (see page ax-147). Drain the automatic transaxle fluid for u241e (see page ax-146). Remove front axle hub nut (see page ah-6) Disconnect front speed sensor lh (see page bc-191) ...

Installation
Install water pump assembly Remove any old seal packing material from the contact surface. Apply a continuous line of seal packing as shown in the illustration. Seal packing: toyota genuine seal parking black, three bond 1207b or equivalent Standard seal diameter: 2.2 To 2. ...

В© 2011-2022 Copyright www.trav4.net