Vehicle features and options
This chapter describes all standard, country-specific and optional features offered with the series.
It also describes features and functions that are not necessarily available in your vehicle, e.g., due to the selected options or country versions. This also applies to safety-related functions and systems.
When using these functions and systems, the applicable laws and regulations must be observed.
Concept
The menu centrally displays all messages arriving in the vehicle in list form.
General information
The following messages can be displayed:
The number of messages is additionally displayed in the status field.
The Messages menu can also be created as Widget.
Retrieving messages
Via iDrive:
Deleting messages
All messages, except Check Control messages or messages from the vehicle manufacturer, can be deleted from the list.
Check Control messages or messages from the vehicle manufacturer are displayed as long as they are relevant.
Via iDrive:
"Delete all notifications"
Adjusting
The following settings can be adjusted:
Via iDrive:
Time
Setting the time zone
Via iDrive:
The setting is stored for the driver profile currently used.
Setting the time
Via iDrive:
Setting the time format
Via iDrive:
The setting is stored for the driver profile currently used.
Automatic time setting
Depending on your vehicle's optional features, the time, date and, if needed, the time zone are updated automatically.
Via iDrive:
The setting is stored for the driver profile currently used.
Date
Setting the date
Via iDrive:
Setting the date format
Via iDrive:
The setting is stored for the driver profile currently used.
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column of the table. Check each symptom by checking the
suspected areas in the order they are listed. Re ...
Ecm / pcm internal engine off timer performance
Dtc summary
Description
To ensure the accuracy of the evap (evaporative emission) monitor values, the
soak timer, which is built
into the ecm, measures 5 hours (+-15 minutes) from when the ignition switch is
turned off, before the
monitor is run. This allows the fuel to cool down, wh ...
How to proceed with troubleshooting
Hint:
Use these procedures to troubleshoot the supplemental
restraint system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage*
Standard voltage:
11 to 14 v
If the voltage is below 11 v, recharge or replace the battery
before proceeding.
...