Concept
The system can help prevent accidents involving pedestrians and cyclists. In the event of an accident, the system may reduce impact speed.
The system sounds a warning in the city speed range before an imminent collision and activates brakes independently, if needed.
General information
The system issues a warning of a possible risk of collision with pedestrians and cyclists at speeds above approx. 3 mph/5 km/h.
The system reacts to pedestrians and cyclists who are within the detection range of the system.
Depending on the equipment version, the system is controlled by the following sensors:
Detection range
The detection area in front of the vehicle is divided into two areas:
A collision is imminent if pedestrians are located within the central area. A warning is issued about pedestrians who are located within the extended area only if they are moving in the direction of the central area.
Safety information
Warning
The system cannot serve as a substitute for the driver's personal judgment in assessing visibility and traffic situation. There is a risk of accident.
Adjust driving style to traffic conditions. Watch traffic closely and actively intervene where appropriate.
Warning
Indicators and warnings cannot serve as a substitute for the driver's personal judgment. Due to its limits, the system may not issue warnings or reactions, or these may be issued late or in a manner that is not consistent with their normal use. There is a risk of accident. Adjust driving style to traffic conditions. Watch traffic closely and actively intervene where appropriate.
Warning
Due to system limits, individual functions can malfunction during tow-starting/towing with the Intelligent Safety systems activated. There is a risk of accident. Switch all Intelligent Safety systems off prior to tow-starting/towing.
Overview
Button in the vehicle
Intelligent Safety
Camera
The camera is installed near the interior mirror.
Keep the windshield in front of the interior mirror clean and clear.
With radar sensor
The radar sensor is located in the lower area of the front bumper.
Always keep radar sensor clean and unobstructed.
If the vehicle becomes
stuck
Carry out the following procedures if the tires spin or the vehicle
becomes stuck in mud, dirt or snow:
Stop the engine. Set the parking brake and shift the shift lever to p.
Remove the mud, snow or sand from around the stuck tire.
Place wood, stones or some other material to help provide t ...
Rear no. 2 Suspension arm
Components
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove rear wheel
Disconnect no. 2 Parking brake cable
assembly (see page pb-8)
Disconnect skid control sensor wire (for
2wd) (see page bc-198)
D ...
Compressor solenoid circuit (2005/11-2006/01)
Description
In this circuit, the compressor receives a refrigerant compression demand
signal from the air conditioning
amplifier. Based on this signal, the compressor changes the degree of
refrigerant compression.
Wiring diagram
Inspection procedure
Read value of intelligent ...