Concept
The lighter socket can be used as a socket for electrical equipment when standby and driveready state are switched on.
General information
The total load of all sockets must not exceed 140 watts at 12 volts.
Do not damage the socket by using non-compatible connectors.
Safety information
Warning
Devices and cables in the unfolding area of the airbags, such as portable navigation devices, can hinder the unfolding of the airbag or be thrown around in the car's interior during unfolding.
There is a risk of injury. Make sure that devices and cables are not in the airbag's area of unfolding.
NOTICE
Battery chargers for the vehicle battery can work with high voltages and currents, which means that the 12 volt on-board network can be overloaded or damaged. There is a risk of damage to property. Only connect battery chargers for the vehicle battery to the starting aid terminals in the engine compartment.
NOTICE
If metal objects fall into the socket, they can cause a short circuit. There is a risk of damage to property.
Front center armrest
The center armrest contains a socket.
Front center console
Push the cover forward until it engages.
A socket is located between the cup holders.
Rear center console
Without rear console: opening and closing
One socket is located in the rear center console.
Open: press on the cover.
To close: press the cover closed again.
With rear console: opening and closing
Push the cover backward until it engages.
A socket is located between the cup holders.
Tap the cover on the handle bar to close it.
With rear console: rear center armrest
The center armrest contains a socket.
In the cargo area
A socket is located on the right side in the cargo area. Unfold the cover.
How to proceed with troubleshooting
Hint:
Use these procedures to troubleshoot the vehicle stability
control system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage
Standard voltage:
11 to 14 v
If the voltage is below 11 v, recharge or replace the battery
before proceedin ...
Bottle holders
Front
Rear
Caution
Items unsuitable for the bottle holder
Do not place anything other than a bottle in the bottle holders.
Other items may be thrown out of the holders in the event of an accident or
sudden braking and cause injury.
Notice
Items that should not be stowed in the bott ...
Inspection
Inspect camshaft position sensor
Measure the resistance of the sensor.
Standard resistance
Notice:
Cold and hot mean the temperature of the coils
themselves. Cold is from -10 to 50°c (14 to 122
°f) and hot is from 50 to 100°c (122 to 212°f).
If the result is not as specif ...