Toyota RAV4 manuals

BMW 7 Series (G11/G12) 2015-2022 Owners Manuals: Steptronic transmission- Launch Control

BMW 7 Series (G11/G12) 2015-2022 Owners Manuals / Controls / Driving / Steptronic transmission- Launch Control

Concept

Launch Control enables optimum acceleration on surfaces with good traction under dry surrounding conditions.

General information

The use of Launch Control causes premature component wear since this function represents a very heavy load for the vehicle.

Do not use Launch Control during the break-in period.

Do not steer the steering wheel when driving off with Launch Control.

Additional information: Breaking-in period

Functional requirement

Launch Control is available when the engine is at operating temperature. The engine is at operating temperature after an uninterrupted trip of at least 6 miles/10 km.

Start with launch control

  1. Switch on drive-ready state.
  2. Press the button. TRACTION
    is displayed in the instrument cluster and the indicator light for DSC OFF lights up.
  3. Engage selector lever position S.
  4. With the left foot, forcefully press down on the brake.
  5. Press and hold down the accelerator pedal beyond the resistance point at the full throttle position, kickdown.

    A flag symbol is displayed in the instrument cluster.

  6. The starting engine speed adjusts. Wait briefly until the engine speed is constant.

    Keep accelerator pedal in this position.

  7.  Release the brake within 3 seconds after the flag symbol illuminates.

    The vehicle accelerates.

    Upshifting occurs automatically as long as the flag symbol is displayed and the accelerator pedal is not released.

Repeated use during a trip

After Launch Control has been used, the transmission must cool down for approx. 5 minutes before Launch Control can be used again.

Launch Control adjusts to the surrounding conditions, when used again.

After using Launch Control

To increase vehicle stability, activate DSC Dynamic Stability Control again as soon as possible.

System limits

An experienced driver may be able to achieve better acceleration values in DSC OFF mode.

Steptronic transmission- Manual mode M/S
Concept Manual gear-shifting is possible in manual mode. Activating manual mode Press the selector lever to the left from selector lever position D, arrow 1. Push the selector lever forward or ...

Displays
...

Other materials:

Valet parking mode
Concept In the valet parking mode, the Control Display is locked. The operation via iDrive is no longer possible. E.g., this mode can be used when the vehicle is handed over for valet parking. General information In the valet parking mode, it is not possible to change vehicle settings via iDrive. P ...

Exhaust pipe
Installation Install front exhaust pipe assembly Using a vernier caliper, measure the free length of the compression spring. Minimum length: 41.5 Mm (1.634 In.) If the length is less than the minimum, replace the compression spring. Install a new gasket by hand so that its ...

Tire pressure warning ecu
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove glove compartment door assembly (see page i ...

В© 2011-2022 Copyright www.trav4.net