Description
If any of the following conditions are detected, the abs warning light remains on:
Hint:
The intelligent tester may not be used when there is a malfunction in the skid control ecu.
Wiring diagram
Inspection procedure
Result
Ok: the skid control ecu connector is properly installed.
Standard resistance
Standard voltage
Ok: the abs warning light is turned on or off.
Hint:
When the abs warning light remains illuminated, opens in the wire harness of the combination meters or abnormalities in the meter circuit should be considered.
Replace abs and traction actuator assembly
Diagnostic trouble code chart
If a dtc is displayed during the dtc check, check the circuit
listed in the table below and proceed to the page given.
Hint:
*1: "Comes on" means the malfunction indicator lamp
(mil) illuminates.
*2: "Dtc stored" means the ecm memorizes the
malfunction code if the ecm ...
Terminals of ecu (2006/01- )
Check air conditioning amplifier
Measure the voltage and resistance of the
connectors.
Hint:
Check from the rear of the connector while it is
connected to the air conditioning amplifier.
Hint:
*: For 2gr-fe
Using an oscilloscope, check waveform 1.
Can communi ...
Driver side seat belt warning light does not operate
Description
When the ignition switch is on, the center airbag sensor transmits front seat
inner belt status signals to
the combination meter through the can bus line. If the driver seat belt is not
fastened, the combination
meter blinks the driver side seat belt warning light. If the seat bel ...