Toyota RAV4 Service Manual: Accelerator pedal rod

Installation

Install ecm Install the 2 brackets to the ecm with the 4 screws. Torque: 3.0 N*m (30 kgf*cm, 27 in.*Lbf) Connect the 2 ecm connectors. Notice: When connecting the connector, ma ...

On-vehicle inspection

Check accelerator pedal rod Check the voltage. Connect the intelligent tester to the dlc3. Turn the ignition switch on Turn the intelligent tester on. Select the menu items: d ...

Other materials:

Front passenger side rear airbag sensor circuit malfunction
Description The rear airbag sensor rh consists of parts including the diagnostic circuit and the lateral deceleration sensor. When the center airbag sensor receives signals from the lateral deceleration sensor, it determines whether or not the srs should be activated. Dtc b1635/24 i ...

Removal
Notice: Do not heat the vehicle body, emblem and name plate excessively. Hint: When removing the emblem and name plate, heat the vehicle body, emblem and name plate using a heat light. Standard heating temperature Remove no. 1 Back door emblem assembly Put protective tape aroun ...

Pressure control solenoid "A" electrical (shift solenoid valve sl1)
Description Shifting from 1st to o/d is performed in combination with the on and off operation of the shift solenoid valves sl1 and sl2, which are controlled by the ecm. If an open or short circuit occurs in any of the shift solenoid valves, the ecm controls the remaining normal shift soleno ...