Toyota RAV4 (XA40) 2013-2018 Owners Manual: Activating the automatic high beam system
Push the lever away from you with
the headlight switch in 
position.
The automatic high beam indicator will come on when the headlights are turned on automatically to indicate that the system is active.
Automatic high beam
The automatic high beam uses an in-vehicle camera sensor to
assess the brightness of streetlights, the lights of oncoming and
preceding vehicles, etc., And automatically turns high beam on
or off a ...
High beam automatic turning on or off conditions
When all of the following conditions are fulfilled, high beam will be
automatically turned on:
Vehicle speed is above approximately 21 mph (34 km/h).
The area ahead of the vehicle is dark.
Th ...
Other materials:
Checking and replacing
fuses
If any of the electrical components do not operate, a fuse may
have blown. If this happens, check and replace the fuses as necessary.
Vehicles without a smart key system:
turn the engine switch to the “lock” position.
Vehicles with a smart key system:
turn the engine switch off.
Aft ...
Reporting safety defects
for u.S. Owners
If you believe that your vehicle has a defect which could cause a
crash or could cause injury or death, you should immediately
inform the national highway traffic safety administration
(nhtsa) in addition to notifying toyota motor sales, u.S.A., Inc.
(Toll-free: 1-800-331-4331).
If nhtsa re ...
Throttle actuator control motor current range / performance
Description
The etcs (electronic throttle control system) has a dedicated power supply
circuit. The voltage (+bm)
is monitored and when it is low (less than 4 v), the ecm determines that there
is a malfunction in the
etcs and cuts off the current to the throttle actuator.
When the volt ...
