Toyota RAV4 (XA40) 2013-2018 Owners Manual: Adjusting the settings
- To adjust the fan speed, turn the fan speed control dial clockwise (increase) or counterclockwise (decrease).
Turning the dial to “0” turns off the fan.
- To adjust the temperature setting, turn the temperature control dial clockwise (warm) or counterclockwise (cool).
If 
is not pressed, the
system will blow ambient temperature air or
heated air.
- To select the air outlets, set the air outlet selector dial to the desired position.
The positions between the air outlet selections shown below can also be selected for more delicate adjustment.
Manual air conditioning
system
Air outlet selector dial
Fan speed control dial
Temperature control dial
Cooling and dehumidification
function on/off button
Outside/recirculated air mode
button
...
Defogging the windshield
Set the air outlet selector dial to
position.
Set the outside/recirculated air
mode button to outside air mode if
recirculated air mode is used.
Perform the following operations a ...
Other materials:
Luggage room light
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove back door center garnish (see page
ed-59)
...
Catalyst monitor (active air-fuel ratio control type)
Preconditions
The monitor will not run unless:
The mil is off.
Drive pattern
Connect the intelligent tester to the dlc3.
Turn the ignition switch on.
Turn the tester on.
Clear dtcs (if set) (see page es-35).
Start the engine and warm it up.
Drive the vehicle at be ...
If the vehicle battery is discharged
The following procedures
may be used to start the
engine if the vehicle's battery
is discharged.
You can also call your
Toyota dealer or a qualified
repair shop.
Restarting the engine
If you have a set of jumper (or
booster) cables and a second
vehicle with a 12-volt battery,
you can jump start you ...
