Toyota RAV4 (XA40) 2013-2018 Owners Manual: Adjusting the settings manually
- To adjust the fan speed, press
on
to increase the fan
speed and
to
decrease the fan speed.Press
to turn the fan off. - To adjust the temperature setting, turn
clockwise to
increases the temperature and turn
counterclockwise to
decreases the temperature.
The air conditioning system switches between individual and simultaneous
modes each time 
is pressed.
Simultaneous mode (the indicator on 
is on):
the driver’s side temperature control dial can be used to adjust the temperature
for the driver’s and passenger’s side. At this time, operate the
passenger’s side temperature control dial to enter individual mode.
Individual mode (the indicator on 
is off):
the temperature for the driver’s and passenger’s side can be adjusted
separately.
- To change the air outlets, press
or
on
.
The air outlets used are switched each time either side the button is pressed.
Using the automatic air conditioning system
Press .
The dehumidification function begins to operate. Air outlets and fan speed
are automatically adjusted according to the temperature setting and
humidity.
Turn clockwis ...
Defogging the windshield
Press .
The dehumidification function
operates and fan speed increases.
Set the outside/recirculated air
mode button to outside air mode if
the recirculated air mode is used.
(It may s ...
Other materials:
Starting system
Parts location
System diagram
The starting system rotates the starter motor according to the
signals from the ignition switch and pnp switch.
...
Diagnostic trouble code chart
If a dtc is displayed during the dtc check, check the circuit
listed for the dtc in the table below (refer to the appropriate
page).
Hint:
When the srs warning light remains on and the normal
system code is output, a decrease in the source voltage is
likely to occur. This malfunction is n ...
Freeze frame data
Freeze frame data
Notice:
It is difficult to show the specified values
(judgment values) clearly because freeze frame
data values change significantly due to
differences in measurement conditions,
surroundings, or vehicle conditions. For this
reason, there may be a problem even w ...
