Toyota RAV4 Service Manual: Air conditioning control assembly (for automatic air conditioning system)
Components
Removal
- Disconnect cable from negative battery terminal
Notice:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove no. 2 Instrument cluster finish panel center (see page ip-5)
- Remove no. 1 Instrument cluster finish panel center (see page ip-5)
- Remove radio receiver (see page ip-5)
- Remove air conditioning control assembly
- Remove the 2 screws.
- Using a screwdriver, detach the 3 clips.
Hint:
Tape the screwdriver tip before use.
- Connect the connectors and remove the air conditioning control.
Installation
- Install air conditioning control assembly
- Install air conditioning control assembly
- Connect the connectors.
- Attach the 3 clips to install the air conditioning control.
- Install the 2 screws.
- Install radio receiver (see page ip-10)
- Install no. 1 Instrument cluster finish panel center (see page ip-10)
- Install no. 2 Instrument cluster finish panel center (see page ip-10)
- Connect cable to negative battery terminal
- Check srs warning light
- Check the srs warning light (see page rs-37).
Heater relay
On-vehicle inspection
Inspect relay (marking: htr)
Measure the resistance of the htr relay.
Standard resistance
If the result is not as specified, replace the relay. ...
Air conditioning control assembly (for manual air conditioning system)
Components
Removal
Disconnect cable from negative battery
terminal
Notice:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent air ...
Other materials:
No signal from transmitter id
Description
The tire pressure warning valve and transmitter constantly sends radio waves
to the tire pressure warning
ecu.
Under the following conditions, the tire pressure warning antenna and receiver
is unable to receive the
signals from the tire pressure warning valve and transmitte ...
Selecting shift ranges in the s position
To enter s mode, shift the shift lever to s. Shift ranges can be selected
by operating the shift lever, allowing you to drive in the shift range of
your choosing. The shift range can be selected by the shift lever.
Upshifting
Downshifting
The selected shift range, from 1 to
6, will be di ...
Evaporative emission system reference orifice
Dtc summary
Hint:
The reference orifice is located inside the canister pump module.
Description
The description can be found in the evap (evaporative emission) system (see
page es-335).
Inspection procedure
Refer to the evap system (see page es-340).
Monitor description
5 Hours* af ...
