Toyota RAV4 Service Manual: Air conditioning control panel does not operate
Description
This circuit consists of the air conditioning control and the air conditioning amplifier. When the air conditioning control is operated, signals are transmitted to the air conditioning amplifier through the lin communication system.
If the lin communication system malfunctions, the air conditioning amplifier does not operate even if the air conditioning control is operated.
Wiring diagram
Inspection procedure
- Check wire harness (air conditioning control assembly - body ground)
- Disconnect the air conditioning control assembly connector.
- measure the resistance of the wire harness side connector.
Standard resistance
- Check wire harness (air conditioning control assembly - battery)
- Disconnect the e23 air conditioning control assembly connector.
- Measure the voltage of the wire harness side connector.
Standard voltage
- Check wire harness (air conditioning amplifier - air conditioning control)
- Disconnect the e23 control connector.
- Disconnect the e37 amplifier connector.
- Measure the resistance of the wire harness side connectors.
Standard resistance
- Replace air conditioning amplifier
- Replace the air conditioning control with a new or properly functioning one.
- Operate the air conditioning control to check that it functions properly.
Replace air conditioning amplifier
Multiplex communication circuit
Description
The air conditioning amplifier communicates data with the ecm and combination
meter through the can
communication system.
Wiring diagram
Inspection procedure
Check dt ...
Blower motor circuit
Description
The blower motor is operated by signals from the air conditioning amplifier.
Blower motor speed signals
are transmitted in accordance with changes in the duty ratio.
Wiring diagra ...
Other materials:
Occupant classification ecu
Components
On-vehicle inspection
Inspect occupant classification ecu
(vehicle not involved in collision)
Perform a diagnostic system check (see page rs-
236).
Inspect occupant classification ecu
(vehicle involved in collision)
Perform a diagnostic system check (see p ...
Operation check
Inspect driver side seat belt warning light
Turn the ignition switch on.
When the driver seat belt is not fastened, check that
the driver seat belt warning light on the combination
meter blinks.
When the driver seat belt is fastened, check that the
driver seat belt warning light o ...
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Disconnect cable from positive battery
terminal
Remove battery clamp
...
