Toyota RAV4 manuals

Toyota RAV4 Owners Manual: Air conditioning filter

The air conditioning filter must be changed regularly to maintain air conditioning efficiency.

Removal method

  1. Vehicles without a smart key system: turn the engine switch to the “lock” position.

    Vehicles with a smart key system: turn the engine switch off.

  2. Open the glove box. Slide off the damper.

Toyota RAV4. Air conditioning filter


  1. Push in each side of the glove box to disconnect the claws.

Toyota RAV4. Air conditioning filter


  1. Remove the filter cover.

Toyota RAV4. Air conditioning filter


  1. Remove the air conditioning filter and replace it with a new one.

    The marks shown on the filter
    should be pointing up.

Toyota RAV4. Air conditioning filter


Changing interval

Inspect and replace the air conditioning filter according to the maintenance schedule. In dusty areas or areas with heavy traffic flow, early replacement may be required. (For scheduled maintenance information, please refer to the “owner’s manual supplement” or “scheduled maintenance”.)

If air flow from the vents decreases dramatically

The filter may be clogged. Check the filter and replace if necessary.

Notice

When using the air conditioning system

Make sure that a filter is always installed.

Using the air conditioning system without a filter may cause damage to the system.

Wheels
If a wheel is bent, cracked or heavily corroded, it should be replaced. Otherwise, the tire may separate from the wheel or cause a loss of handling control. Wheel selection When replacing wheels, ...

Wireless remote control/electronic key battery
Replace the battery with a new one if it is depleted. You will need the following items: Flathead screwdriver Small flathead screwdriver Lithium battery cr2016 (vehicles without a smart key s ...

Other materials:

Using the mechanical key (vehicles with a smart key system)
To take out the mechanical key, push the release button and take the key out. The mechanical key can only be inserted in one direction, as the key only has grooves on one side. If the key cannot be inserted in a lock cylinder, turn it over and reattempt to insert it. After using the mec ...

Automatic transaxle unit
Components ...

Pressure control solenoid "d" electrical (shift solenoid valve slt)
Description Refer to dtc p2714 (see page ax-91). Monitor description When an open or short in the shift solenoid valve slt circuit is detected, the ecm interprets this as a fault. The ecm will illuminate the mil and store the dtc. Monitor strategy Typical enabling conditions ...

© 2011-2024 Copyright www.trav4.net