Toyota RAV4 (XA40) 2013-2018 Service Manual: Air conditioning system (for automatic air conditioning system)
- Precaution
- Parts location (2005/11-2006/01)
- Parts location (2006/01- )
- System diagram
- System description
- How to proceed with troubleshooting (2005/11-2006/01)
- How to proceed with troubleshooting (2006/01- )
- Customize parameters
- Problem symptoms table (2005/11-2006/01)
- Problem symptoms table (2006/01- )
- Terminals of ecu (2005/11-2006/01)
- Terminals of ecu (2006/01- )
- Diagnosis system
- Dtc check / clear
- Check mode procedure
- Data list / active test (2005/11-2006/01)
- Data list / active test (2006/01- )
- Diagnostic trouble code chart (2005/11-2006/01)
- Diagnostic trouble code chart (2006/01- )
Air conditioning
...
Precaution
If any of following conditions are met,
keep engine idling with a/c on (engine
speed at less than 2000 rpm) for at least 1
minute:
Refrigerant gas has been refilled or a/c parts have
...
Other materials:
Dtc check / clear
Check dtc
Hint:
When dtc b1650/23 is detected as a result of
troubleshooting for the airbag system, troubleshoot
the occupant classification system.
Use the intelligent tester (with can vim) to read and
clear dtcs, otherwise the dtcs cannot be read and
cleared.
Connect ...
Thermostat
Components
Removal
Remove no. 1 Engine under cover
Drain engine coolant (see page co-6)
Remove radiator support opening cover
Disconnect no. 2 Radiator hose
Remove water inlet
Remove the 2 nuts and disconnect the water inlet
from the cylinder block.
Remove thermostat
...
For vehicles equipped with vehicle stability (vsc) system
Notices when using drum tester
Before beginning testing, disable the vsc. To
disable the vsc, turn the ignition switch off
and connect sst to terminals 12 (ts) and 4
(cg) of the dlc3.
Sst 09843-18040
Notice:
Confirm that the vsc warning light blinks.
Vsc system will be r ...
