Toyota RAV4 Service Manual: Air-fuel ratio (a/f) and heated oxygen (ho2) sensor heater monitors (front a/f and rear ho2 sensor type)
- Preconditions
The monitor will not run unless:
- The mil is off.
- Drive pattern
- Connect the intelligent tester to the dlc3.
- Turn the ignition switch on.
- Turn the tester on.
- Clear dtcs (if set) (see page es-35).
- Start the engine.
- Allow the engine to idle for 10 minutes or more.
- Drive the vehicle at 40 km/h (25 mph) or more for at least 2 minutes.
- Monitor status
- Check the readiness monitor status displayed on the tester.
If the status does not switch to compl (complete), make sure that the preconditions have been met, and repeat steps from (5) to (7) described in the drive pattern above.
Air-fuel ratio (a/f) and heated oxygen (ho2) sensor
monitors (active air-fuel ratio control type)
Preconditions
The monitor will not run unless:
2 Minutes or more have elapsed since the engine
was started.
The engine coolant temperature (ect) is 75°c
(167°f) or more.
Cumula ...
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected area" column of
th ...
Other materials:
General maintenance (2005/11-2006/01)
Inspect drive belt (see page em-6)
Replace spark plugs (see page ig-7)
Replace air cleaner filter
Remove the air filter.
Visually check that the air filter is not excessively
damaged or oily.
Replace the air filter with a new one, if necessary.
Replace engine oil and oil fil ...
Fail-safe chart
If a problem occurs in the electric power steering system, the
p/s warning light will come on in the combination meter and
steering power assist will be stopped, fixed at a particular
point, or decreased simultaneously to protect the system.
Hint:
The amount of power assist may be decreased ...
Installing child restraints
Follow the child restraint system manufacturer’s instructions.
Firmly secure child restraints to the seats using the latch
anchors or a seat belt. Attach the top tether strap when installing
a child restraint.
The lap/shoulder belt can be used if your child restraint system
is not compati ...
