Toyota RAV4 manuals

Toyota RAV4 Service Manual: Air inlet control servo motor

Toyota RAV4 Service Manual / Air conditioning / Air inlet control servo motor

Components

Toyota RAV4. Air inlet control servo motor


Removal

  1. Remove blower assembly

  1. Remove the blower (see page ac-203).
  1. Remove air inlet control servo motor (see page ac-210)

Inspection

  1. Inspect air inlet control servo motor (for automatic air conditioning system)

Toyota RAV4. Inspect air inlet control servo motor (for automatic air conditioning system)


  1. Inspect the servo motor operation.

Toyota RAV4. Inspect air inlet control servo motor (for automatic air conditioning system)


  1. Connect the positive (+) lead from the battery to terminal 4 and negative (-) lead to terminal 5, and then check that the arm turns to the "fresh" side smoothly.
  2. Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 4, and then check that the arm turns to the "recirculation" side smoothly.

    If the operation is not as specified, replace the air inlet control servo motor.

  1. Inspect air inlet control servo motor (for manual air conditioning system)

  1. Inspect the servo motor operation.

Toyota RAV4. Inspect air inlet control servo motor (for manual air conditioning system)


Toyota RAV4. Inspect air inlet control servo motor (for manual air conditioning system)


  1. Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 1, and then check that the arm turns to the "fresh" side smoothly.
  2. Connect the positive (+) lead from the battery to terminal 1 and negative (-) lead to terminal 5, and then check that the arm turns to the "recirculation" side smoothly. If the operation is not as specified, replace the air inlet servo motor.

Installation

  1. Install air inlet control servo motor (see page ac-206)

  2. Install blower assembly

  1. Install the blower (see page ac-206).
Blower resistor
On-vehicle inspection Inspect blower motor control Measure the resistance of the blower resistor. Standard resistance If the resistance is not as specified, replace the blower moto ...

Air mix control servo motor (for automatic air conditioning system)
Components Removal Remove air conditioning unit Remove the air conditioning radiator (see page ac- 185). Remove air mix control servo motor (see page ac-191) Inspection ...

Other materials:

Heated oxygen sensor
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove heated oxygen sensor (for bank 1 sensor 2) ...

Parts location
System diagram ...

Installation with latch system
Adjust the seatback to the 8th lock position from the fully reclined position. Fully reclined position 8Th lock position If your child restraint system interferes with a head restraint and cannot be installed properly, install the child restraint system after removing the hea ...

В© 2011-2024 Copyright www.trav4.net