Toyota RAV4 Service Manual: Antenna coil open / short
Description
The transponder key coil receives key code signals from the transponder chip in the key grip. The coil built into the transponder key amplifier amplifies the key code signals and outputs the signal to the transponder key ecu.
Wiring diagram
Inspection procedure
- Read value of intelligent tester (transponder key coil)
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch on with a key that cannot start the engine.
- On the intelligent tester, enter the following menus: diagnosis / obd/mobd / immobiliser / data list / antenna coil. Read the result.
Ok: normal (transponder key coil is normal) appears on the screen.
- Check wire harness (transponder key ecu - transponder key amplifier)
- Disconnect the e46 ecu connector.
- Disconnect the e5 amplifier connector.
- Measure the resistance of the wire harness side connectors.
Standard resistance 
Replace transponder key amplifier
Push switch / key unlock warning switch malfunction
Description
This dtc is output if the transponder key ecu does not detect that the unlock
warning switch is on even
when the ignition switch is on. Under normal conditions, the unlock warning ...
Transponder chip malfunction
Description
This dtc is output when: 1) during key code registration, a key malfunction
occurs; 2) the key code was
unable to be registered properly.
Inspection procedure
Reregister k ...
Other materials:
Hitch
Trailer hitch assemblies have different weight capacities. Toyota recommends
the use of toyota hitch/bracket for your vehicle. For details,
contact your toyota dealer.
If you wish to install a trailer hitch, contact your toyota dealer.
Use only a hitch that conforms to the gross trailer weig ...
Ig2 relay
On-vehicle inspection
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove ig2 relay
Remove the no. 1 Engine room re ...
Inspection
Inspect camshaft position sensor
Measure the resistance of the sensor.
Standard resistance
Notice:
Cold and hot mean the temperature of the coils
themselves. Cold is from -10 to 50°c (14 to 122
°f) and hot is from 50 to 100°c (122 to 212°f).
If the result is not as specif ...
