Toyota RAV4 manuals

Toyota RAV4 Owners Manual: Antenna location and effective range

Antenna location

  1. Antennas outside the cabin
  2. Antennas inside the cabin
  3. Antenna outside the luggage compartment

Toyota RAV4. Antenna location and effective range


Effective range (areas within which the electronic key is detected)

The system can be operated when the electronic key is within about 2.3 Ft. (0.7 M) of either of the outside front door handles and back door opener switch.

(Only the doors detecting the key can be operated.) 


The system can be operated when the electronic key is inside the vehicle.

When the door cannot be locked by the lock sensor on the upper part of the door handle

If the door will not lock even when the topside sensor area is touched, try touching both the topside and underside sensor areas at the same time.


Alarms and warning indicators

A combination of exterior and interior alarms as well as warning lights are used to prevent theft of the vehicle and unforeseeable accidents resulting from erroneous operation. Take appropriate measures for the warning light that comes on.

The following table describes circumstances and correction procedures when only alarms are sounded.

Alarm

Situation

Correction procedure

Exterior alarm sounds once for 5 seconds An attempt was made to lock the doors using the smart key system while the electronic key was still inside the vehicle. Retrieve the electronic key from the vehicle and lock the doors again.
An attempt was made to lock the vehicle while a door was open. Close all of the doors and lock the doors again.
Interior alarm pings once and exterior alarm sounds once for 5 seconds. An attempt was made to lock either front door by opening a door and putting the inside lock button into the lock position, then closing the door with the electronic key still inside the vehicle. Retrieve the electronic key from the vehicle and lock the doors again.
Interior alarm sounds continuously The engine switch was turned to accessory mode while the driver’s door was open (or the driver’s door was opened while the engine switch was in accessory mode). Turn the engine switch off and close the driver’s door.
The driver’s door was opened while any shift position other than p was selected without turning off the engine switch. Shift the shift lever to p.

Switching the door unlock function

It is possible to set which doors the entry function unlocks using the wireless remote control.

  1. Turn the engine switch off.
  2. When the indicator light on the key surface is not on, press and hold   ,

For
approximately 5 seconds while pressing and holding .


The setting changes each time an operation is performed, as shown below.

(When changing the setting continuously, release the buttons, wait for at least 5 seconds, and repeat step 2 .)

Unlocking function

Beep

Holding the driver’s door handle unlocks only the driver’s door. Exterior: beeps 3 times Interior: pings once
Holding a passenger’s door handle Unlocks all the doors.
Holding a door handle unlocks all the doors. Exterior: beeps twice interior: pings once

Battery-saving function

The battery-saving function will be activated in order to prevent the electronic key battery and the vehicle battery from being discharged while the vehicle is not in operation for a long time.

In the following situations, the smart key system may take some time to unlock the doors

If the smart key system has not been used for 14 days or longer, the doors cannot be unlocked at any doors except the driver’s door. In this case, take hold of the driver’s door handle, or use the wireless remote control or the mechanical key, to unlock the doors.

Electronic key battery-saving function

When battery-saving mode is set, battery depletion is minimized by stopping the electronic key from receiving radio waves.

Press twice
while pressing and holding .
Confirm that the electronic key indicator flashes 4 times.

While the battery-saving mode is set, the smart key system cannot be used. To cancel the function, press any of the electronic key buttons.


Conditions affecting operation

The smart key system uses weak radio waves. In the following situations, the communication between the electronic key and the vehicle may be affected, preventing the smart key system, wireless remote control and engine immobilizer system from operating properly.

Note for the entry function

Even when the electronic key is within the effective range (detection areas), the system may not operate properly in the following cases:

Do not leave the electronic key on top of the instrument panel or near the door pockets when exiting the vehicle. Depending on the radio wave reception conditions, it may be detected by the antenna outside the cabin and the door will become lockable from the outside, possibly trapping the electronic key inside the vehicle.

As long as the electronic key is within the effective range, the doors may be locked or unlocked by anyone. However, only the doors detecting the electronic key can be used to unlock the vehicle.

Even if the electronic key is not inside the vehicle, it may be possible to start the engine if the electronic key is near the window.

The doors may unlock or lock if a large amount of water splashes on the door handle, such as in the rain or in a car wash when the electronic key is within the effective range. (The doors will automatically be locked after approximately 60 seconds if the doors are not opened and closed.)

If the wireless remote control is used to lock the doors when the electronic key is near the vehicle, there is a possibility that the door may not be unlocked by the entry function. (Use the wireless remote control to unlock the doors.)

Note for locking the doors

Note for the unlocking function

When the vehicle is not driven for extended periods

To operate the system properly

Make sure to carry the electronic key when operating the system. Do not get the electronic key too close to the vehicle when operating the system from the outside of the vehicle.

Depending on the position and holding condition of the electronic key, the key may not be detected correctly and the system may not operate properly. (The alarm may go off accidentally, or the door lock prevention function may not operate.)

If the smart key system does not operate properly

Electronic key battery depletion

To avoid serious deterioration, do not leave the electronic key within 3 ft. (1 M) of the following electrical appliances that produce a magnetic field:

When the electronic key battery is fully depleted

Customization

Settings (e. G. Smart key system) can be changed.

If the smart key system has been deactivated in a customized setting

Certification for the smart key system

Fcc id: hyq23aab 

Fcc id: hyq14fba

Fcc id: ni4tmlf10-13*

Fcc id: ni4tmlf10-51*

*: U.S.A. Only

Note:

This device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Fcc warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

For vehicles sold in canada

Note:

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

This device complies with industry canada licence-exempt rss standard(s).

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Caution

Caution regarding interference with electronic devices

Ask your toyota dealer for details on disabling the entry function.

Unlocking and locking the doors
Front doors Grip the driver’s door handle to unlock the door. Grip the passenger’s door handle to unlock all the doors.* Make sure to touch the sensor on the back of the handle. The door ...

Wireless remote control
Function summary The wireless remote control can be used to lock and unlock the vehicle. It also opens and closes the back door. Vehicles without a smart key system Locks all the doors Unlo ...

Other materials:

Air fuel ratio sensor
Components On-vehicle inspection Check air fuel ratio compensation system Connect the intelligent tester to the dlc3. Turn the ignition switch on. Select the following menu items: data list / a/fs b1 s1 and o2s b1 s2. Warm up the a/f sensor with the engine speed at 2,500 ...

Skid control sensor (for 2wd)
Components Removal Hint: Use the same procedures for the lh side and rh side. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery termin ...

Camshaft position correlation (bank 1 sensor a)
Dtc P0016 P0016 crankshaft position - camshaft position correlation (bank 1 sensor a) Description In the vvt (variable valve timing) system, the appropriate intake valve open and close timing is controlled by the ecm. The ecm performs intake valve control by performing the following: 1) cont ...

© 2011-2024 Copyright www.trav4.net