Description
Refer to the description of "auto lsd indicator light remains on" (see page bc-164).
Wiring diagram
Refer to the auto lsd indicator light circuit (see page bc-165).
Inspection procedure
Result
Ok: on (downhill assist control switch is on) appears on the screen.
Ok: the auto lsd indicator light turns on and off.
Replace abs and traction actuator assembly
Standard resistance
Standard resistance
Replace abs and traction actuator assembly
Terminals of ecu
Check instrument panel junction block (main body ecu)
Disconnect the ib and ie junction block connectors.
Measure the voltage and resistance of the wire
harness side connectors.
Reconnect the ib and ie junction block connector.
Measure the voltage of the wire harness ...
Fuel system
Precaution
Before working on fuel system
Do not work near an open flame.
Keep gasoline away from rubber and leather parts.
Discharge the fuel pressure before disconnecting
the fuel line to prevent gasoline from spilling out.
Refer to the following procedure.
Discharge fuel ...
Short to b+ in can bus line
Description
There may be a short circuit between the can bus line and +b when there is
resistance between
terminals 6 (canh) and 16 (bat) or terminals 14 (canl) and 16 (bat) of the dlc3.
Wiring diagram
Inspection procedure
Notice:
Turn the ignition switch off before measuring ...