Toyota RAV4 (XA40) 2013-2018 Service Manual: Automatic transaxle system
- Precaution
- Parts location
- Road test
- Mechanical system tests
- Hydraulic test
- Manual shifting test
- Monitor drive pattern
- Problem symptoms table
- Terminals of ecm
- Diagnosis system
- Dtc check / clear
- Check mode procedure
- Fail-safe chart
- Data list / active test
- Diagnostic trouble code chart
Precaution
Notice:
Perform the reset memory procedures (a/t
initialization) when replacing the automatic transaxle
assembly, engine assembly or ecm (see page ax-18).
Hint:
Reset memory cannot be completed b ...
Other materials:
Inspection
Inspect automatic transaxle oil panel
sub-assembly
Remove the magnets and use them to collect any
steel chips. Examine the chips and particles in the
pan and on the magnet to determine what type of
wear has occurred in the transaxle.
Steel (magnetic): bearing gear and plate ...
Parts location
System diagram
The configuration of the electronic control system in the
u140f automatic transaxle is as shown in the following chart.
System description
System description
The electronic controlled automatic transaxle
(ect) is an automatic transaxle that elect ...
Precaution
Check that the battery cables are connected to the
correct terminals.
Disconnect the battery cables if a quick charge is
given to the battery.
Do not perform tests with a high voltage insulation
resistance tester.
Never disconnect the battery while the engine is
running.
Check tha ...
