Toyota RAV4 Service Manual: Back door outside garnish
Components
Removal
- Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove back door center garnish (see page ed-59)
- Remove back door side garnish lh (see page ed-59)
- Remove back door side garnish rh (see page ed-59)
- Remove back door courtesy light switch assembly (see page li-122)
- Remove back door trim board (see page ed- 59)
- Remove lower back door outside garnish sub-assembly lh
- Remove the screw and the 7 clips.
- Remove the back door outside garnish and disconnect the connector
- Remove the license plate light (see page li-110 ).
- Remove upper back door outside garnish sub-assembly lh
- Remove the screw and the 6 clips.
- Remove the back door outside garnish.
- Remove lower back door outside garnish sub-assembly rh
- Remove the 5 clips and detach the claw.
- Remove the back door outside garnish.
- Remove upper back door outside garnish sub-assembly rh
- Remove the 6 clips and back door outside garnish.
Installation
- Install upper back door outside garnish sub-assembly rh
- Attach the 6 clips to install the back door outside garnish.
- Install lower back door outside garnish sub-assembly rh
- Install the back door outside garnish.
- Attach the claw and 5 clips.
- Install upper back door outside garnish sub-assembly lh
- Attach the 6 clips to install the back door outside garnish.
- Install the screw.
- Install lower back door outside garnish sub-assembly lh
- Install the license plate light (see page li-111).
- Connect the connector.
- Attach the 7 clips to install the back door outside garnish.
- Install the screw.
- Install back door trim board (see page ed- 66)
- Install back door courtesy light switch assembly (see page li-123)
- Install back door side garnish lh (see page ed-67)
- Install back door side garnish rh (see page ed-67)
- Install back door garnish center (see page ed-67)
- Connect cable to negative battery terminal
Installation
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
When installing the moulding, heat the vehicle body and
moulding using a heat ligh ...
Other materials:
General maintenance (2006/01- )
Inspect steering linkage and gear housing
Check the steering wheel free play.
Check the steering linkage for looseness or
damage.
Check that the tie rod ends do not have
excessive play.
Check that the dust seals and boots are not
damaged.
Check that the boot clamps are not ...
Stop light switch circuit
Description
While driving with the cruise control, if the ecm detects that the brake
pedal is depressed, the cruise
control operation will be canceled. The stop light switch sends brake pedal
status signals to the ecm.
When the brake pedal is not depressed, terminal st1- is equal to the ...
Bus ic communication malfunction
Description
The air conditioning harness connects the air conditioning amplifier and the
servos. The air conditioning
amplifier supplies power and sends operation instructions to each servo through
the air conditioning
harness. Each servo sends damper position information to the air condi ...
