Notice:
Notice:
When testing a gold-plated female terminal, always use a gold-plated male terminal.
Never rub the contact point using sandpaper as the plating may come off.
If it is cut or broken, repair the cover with vinyl tape or replace the wire harness.
Rear speed sensor (for 4wd)
Components
Removal
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery termin ...
General maintenance
Listed below are the general maintenance items that should be
performed at the intervals specified in the “owner’s warranty
information booklet” or “owner’s manual supplement/scheduled
maintenance guide”. It is recommended that any problem
you notice should be brought to the attentio ...
Center airbag sensor assembly malfunction
Description
The center airbag sensor consists of the airbag sensor, the safing sensor,
the drive circuit, the diagnosis
circuit and the ignition control.
If the center airbag sensor receives signals from the airbag sensor, it
determines whether or not the srs
should be activated.
Dt ...