Description
The battery temperature sensor installed on the battery current sensor detects battery temperature.
A thermistor is integrated into the battery temperature sensor, and the resistance in the battery temperature sensor changes according to the battery temperature.
The resistance of the thermistor in the battery temperature sensor decreases as the battery temperature increases. The resistance increases as the temperature decreases.
The battery temperature sensor is connected to the ecm. The ecm supplies 5 v from the thb terminal to the battery temperature sensor through resistor r.
The battery temperature sensor and resistor r are connected in series. This results in fluctuations in the voltage supplied from the thb terminal when the resistance changes according to the battery temperature.
The ecm determines the battery temperature according to fluctuations in voltage. When the battery temperature is high, the ecm determines to reduce the amount of current supplied from the generator in order to protect the battery.
Wiring diagram
Refer to dtc p1550 (see page es-262)
Inspection procedure
Standard resistance
Standard resistance (check for open)
Standard resistance (check for short)
Rear shock absorber
Components
Removal
Hint
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove rear wheel
Remove rear shock absorber assembly lh
Support the no. 2 Suspension arm lh with a jack.
Notice:
Place a wooden or rubber b ...
Dtc check / clear
Check dtc (when using intelligent tester)
Connect the intelligent tester (with can vim) to the
dlc3.
Turn the ignition switch on.
Turn the tester on.
Read the dtcs by following the prompts on the
tester screen.
Hint:
Refer to the intelligent tester operator's manual for
furth ...
Source voltage drop
Description
The srs is equipped with a voltage-increase circuit (dc-dc converter) in the
center airbag sensor in
case the source voltage drops.
When the source voltage drops, the voltage-increase circuit (dc-dc converter)
functions to increase the
voltage of the srs to a normal working lev ...