Toyota RAV4 Service Manual: Blower motor
On-vehicle inspection
- Inspect blower motor (for automatic air conditioning system)
- Disconnect the blower motor connector.
- Connect the positive (+) lead from the battery to
terminal 1 and negative (-) lead to terminal 2, and
then check that the motor operates smoothly.
If the operation is not as specified, replace the blower motor.
- Inspect blower motor (for manual air conditioning system)
- Disconnect the blower motor connector.
- Connect the positive (+) lead from the battery to
terminal 2 and negative (-) lead to terminal 1, and
then check that the motor operates smoothly.
If the operation is not as specified, replace the blower motor.
Blower unit
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Blower resistor
On-vehicle inspection
Inspect blower motor control
Measure the resistance of the blower resistor.
Standard resistance
If the resistance is not as specified, replace the
blower moto ...
Other materials:
Optimal use of the
audio system
On the “sound settings” screen, sound quality (treble/mid/
bass), volume balance can be adjusted.
How to adjust the sound settings and sound quality
Select “-” or “+” to adjust
the treble, mid or bass to
a level between -5 and 5.
Select “front” or “rear” to
adjust the fr ...
Antenna coil open / short
Description
The transponder key coil receives key code signals from the transponder chip
in the key grip. The coil
built into the transponder key amplifier amplifies the key code signals and
outputs the signal to the
transponder key ecu.
Wiring diagram
Inspection procedure
R ...
How to proceed with troubleshooting
Hint:
*: Use the intelligent tester.
Hint:
If the display indicates a communication fault in the tester,
inspect the dlc3.
Hint:
Record or print dtcs and freeze frame data, if necessary.
Hint:
If the engine does not start, first perform the "check dtc"
procedures a ...
