Bluetooth® audio
The bluetooth® audio system enables you to enjoy music played on a portable digital audio player (portable player) from the vehicle speakers via wireless communication.
This audio system supports bluetooth®, a wireless data system capable of playing portable audio music without cables. If your portable player does not support bluetooth®, the bluetooth® audio system will not function.
Bluetooth® phone (hands-free phone system)
This system supports bluetooth®, which allows you to make or receive calls without using cables to connect a cellular phone and the system, and without operating the cellular phone.
Conditions affecting operation
The bluetooth® audio/phone may not operate normally in the following situations:
When transferring ownership of the vehicle
Be sure to initialize the system to prevent personal data from being improperly accessed
About bluetooth®
Bluetooth is a registered trademark of
bluetooth sig, inc. 
Compatible models
Bluetooth® specifications: ver. 1.1, Or higher (recommended: ver. 2.1 + Edr or higher)
?Following profiles:
Portable players must correspond to the above specifications in order to be connected to the bluetooth® audio/phone. However, please note that some functions may be limited depending on the type of portable player.
Cellular phone
Certification
Fcc id: babft0023a
Ic: 2024b-ft0023a
For vehicles sold in the u.S.A. And puerto rico
This device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
For vehicles sold in canada
In english
This device complies with industry canada licence-exempt rss standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
In french
Le présent appareil est conforme aux cnr d’industrie canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Caution
Fcc warning
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radio frequency radiation exposure: this equipment complies with fcc radiation exposure limits set forth for uncontrolled equipment and meets the fcc radio frequency (rf) exposure guidelines in supplement c to oet65. This equipment has very low levels of rf energy that it deemed to comply without maximum permissive exposure evaluation (mpe). But it is desirable that it should be installed and operated with at least 20 cm and more between the radiator and person’s body (excluding extremities: hands, wrists, feet and ankles).
Co-location: this transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
Caution
While driving
Do not operate the portable audio player, cellular phone or connect a device to the bluetooth® system.
Caution regarding interference with electronic devices
Notice
When leaving the vehicle
Do not leave your portable audio player or cellular phone in the vehicle. The inside of the vehicle may become hot, causing damage to the portable audio player or cellular phone.
Using the steering wheel audio switches
Using the bluetooth® audio/phoneUsing an anchor bracket
(for top tether strap)
■ Anchor brackets (for top
tether strap)
Anchor brackets are provided
for each rear seat.
Use anchor brackets when fixing
the top tether strap.
Outboard rear seats
Anchor brackets
Top tether strap
Center rear seat
Anchor bracket
Top tether strap
■ Fixing the top tether strap
to the an ...
Disassembly (2005/11-2006/01)
Remove front axle inboard joint boot no. 2
Clamp lh
One touch type:
Using a screwdriver, remove the no. 2 Inboard
joint boot clamp, as shown in the illustration.
Claw engagement type:
Using needle-nose pliers, remove the no. 2
Inboard joint boot clamp, as shown in t ...
Mechanical system tests
Stall speed test
Hint:
This test is to check the overall performance of the
engine and transaxle.
Notice:
Do not perform the stall speed test longer than 5
seconds.
To ensure safety, perform this test in an open and
level area that provides good traction.
The stall speed test sh ...