Toyota RAV4 Service Manual: Brake
General maintenance
- Inspect brake lines and hoses
Hint:
Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.
- Using a mirror, check the entire circumference and length of the brake lines and hoses for:
- Damage
- Wear
- Deformation
- Cracks
- Corrosion
- Leaks
- Bends
- Twists
- Check all the clamps for tightness and the connections for leakage.
- Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system.
- Check that the lines are installed properly and pass through the center of the grommets.
- Inspect front brake
- Check the front brake pads and discs (see page br- 42).
- Inspect brake linings and drums
- Check the brake linings and drums. Also check the brake linings of the parking brake.
General maintenance (2006/01- )
Inspect drive belt (see page em-7)
Replace spark plugs (see page ig-7)
Replace air cleaner filter
Remove the air filter.
Visually check that the air filter is not excessively
damaged ...
Chassis
...
Other materials:
Installation
Install upper instrument panel
Attach the 6 clips and 5 claws to install the
instrument panel.
Connect the connectors and clamps.
Install the 2 bolts and 2 screws.
Connect the passenger airbag connector.
Install the 2 bolts to the passenger airbag.
Torque: 20 n*m (204 k ...
Short in front driver side - side squib circuit
Description
The driver side - side squib circuit consists of the center airbag sensor and
the front seat side airbag lh.
This circuit instructs the srs to deploy when the deployment conditions are met.
These dtcs are recorded when a malfunction is detected in the driver side - side
sq ...
Steering angle sensor zero point malfunction
Description
The skid control ecu learns the steering sensor zero point every time the
ignition switch is turned on and
the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds.
The ecu also stores the
previous zero point.
If front wheel alignment or the steering wh ...
