Toyota RAV4 Service Manual: Brake pedal load sensing switch
On-vehicle inspection
- Inspect brake pedal load sensing switch
Hint:
- Do not remove the brake pedal load sensing switch from the brake pedal support.
- When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support.
- Disconnect the brake pedal load sensing switch connector.
- Measure the resistance of the switch.
Standard resistance 
If the value is not as specified, replace the brake pedal support assembly (see page br-12).
Steering angle sensor
Components
Removal
Precaution
Caution:
Be sure to read the "precaution" thoroughly
before servicing (see page rs-1).
Disconnect cable from negative battery
terminal
Ca ...
Downhill assist control switch
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Other materials:
Exhaust pipe
Components
Removal
Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove heated oxygen sensor (for bank 1
sensor 2) (s ...
Fuel pressure pulsation damper
Components
Removal
Discharge fuel system pressure (see page
fu-9)
Disconnect cable from negative battery
terminal
Remove no. 1 Engine cover (see page es-410)
Remove air cleaner cap sub-assembly (see
page es-411)
Disconnect fuel main tube (see page fu-10)
Remove fuel pres ...
Power supply relay failure
Description
If the power steering ecu detects these dtcs, it shuts off the motor relay
circuit (built into the power
steering ecu) and stops power assist.
Inspection procedure
Reconfirm dtc
Check for dtc.
Ok:
dtc is not output.
Replace power steering ecu ...
