Toyota RAV4 manuals

Toyota RAV4 Service Manual: Brake warning light remains on

Description

If any of the following conditions are detected, the brake warning light remains on:

  1. The ecu connectors are disconnected from the skid control ecu.
  2. The brake fluid level is insufficient.
  3. The parking brake is applied.
  4. The ebd is defective.

Wiring diagram

Toyota RAV4. Wiring diagram


Inspection procedure

  1. Prepare for inspection

  1. Check that both of the following conditions are satisfied.

Hint:

When the abs warning light remains illuminated, repair the malfunctions in the abs system first.


  1. Check dtc for abs

  1. Check if any abs dtcs are output (see page bc-47).

Result




  1. Check can communication system

  1. Check if the can communication system dtc is output (see page ca-34).

Result




  1. Inspect skid control ecu connector

  1. Check if the skid control ecu connector is properly installed.

Ok: the skid control ecu connector is properly installed.



  1. Check wire harness (skid control ecu - battery and body ground)

Toyota RAV4. Check wire harness (skid control ecu - battery and body ground)


  1. Disconnect the a19 ecu connector.
  2. Measure the resistance of the wire harness side connector.

Standard resistance


  1. Measure the voltage of the wire harness side connector.

Standard voltage




  1. Read value of intelligent tester (parking brake switch)

  1. Using the data list, check for proper functioning of the parking brake switch.

Toyota RAV4. Read value of intelligent tester (parking brake switch)


Ok: when the parking brake lever is operated, the display changes as shown above.



  1. Inspect brake fluid level warning switch

Toyota RAV4. Inspect brake fluid level warning switch


  1. Remove the reservoir tank cap and strainer.
  2. Disconnect the brake fluid level warning switch connector.
  3. Measure the resistance of the switch.

Hint:

A float is placed inside the reservoir. Its position can be changed by increasing or decreasing the brake fluid level.

Standard resistance


Hint:

If there is no problem after the above check is finished, adjust the brake fluid level to the max level.



  1. Check wire harness (level warning switch - combination meter and body ground)

  1. Disconnect the e19 combination meter connector.
  2. Disconnect the a8 switch connector.
  3. Measure the resistance of the wire harness side connectors.

Standard resistance


Toyota RAV4. Check wire harness (level warning switch - combination meter and body ground)




  1. Inspect combination meter

  1. Inspect the combination meter (see page me-15).



Replace abs and traction actuator assembly

  1. Inspect parking brake switch assembly

  1. Remove the parking brake switch.
  2. Measure the resistance of the switch.

Toyota RAV4. Inspect parking brake switch assembly


Standard resistance




  1. Check wire harness (junction block - parking brake switch and body ground)

  1. Disconnect the 1d junction block connector.
  2. Disconnect the e41 switch connector.
  3. Measure the resistance of the wire harness side connectors.

Standard resistance


Toyota RAV4. Check wire harness (junction block - parking brake switch and body ground)




Replace instrument panel junction block

Vsc warning light does not come on
Description Refer to the description of "vsc warning light remains on" (see page bc-139). Wiring diagram Refer to the vsc warning light circuit (see page bc-140). Inspection procedure N ...

Brake warning light does not come on
Wiring diagram Refer to the brake warning light circuit (see page bc-145). Inspection procedure Check can communication system Check if the can communication system dtc is output (see pa ...

Other materials:

Installation
Install camshaft timing oil control valve assembly Apply a light coat of engine oil to the o-ring of the oil control valve. Install the oil control valve with the bolt. Torque: 9.0 N*m (92 kgf*cm, 80 in.*Lbf) Notice: Make sure that the o-ring is not cracked or jammed. Co ...

Reporting safety defects for u.S. Owners
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the national highway traffic safety administration (nhtsa) in addition to notifying toyota motor sales, u.S.A., Inc. (Toll-free: 1-800-331-4331). If nhtsa re ...

Lost communication with front passenger side - side airbag sensor assembly
Description The side airbag sensor rh consists of parts including the diagnostic circuit and the lateral deceleration sensor. When the center airbag sensor receives signals from the lateral deceleration sensor, it determines whether or not the srs should be activated. Dtc b1627/82 i ...

В© 2011-2024 Copyright www.trav4.net