Toyota RAV4 (XA40) 2013-2018 Service Manual: Bus ic communication malfunction
Description
The air conditioning harness connects the air conditioning amplifier and the servos. The air conditioning amplifier supplies power and sends operation instructions to each servo through the air conditioning harness. Each servo sends damper position information to the air conditioning amplifier.
Wiring diagram
Inspection procedure
- Check air conditioning amplifier
- Remove the air conditioning amplifier with its connectors still connected.
- Measure the resistance of the wire harness side connector.
Standard resistance
- Check air conditioning amplifier
- Remove the air conditioning amplifier with its connectors still connected.
- Measure the voltage of the wire harness side connector.
Standard voltage
Replace air conditioning harness assembly
Compressor solenoid circuit (2006/01- )
Description
In this circuit, the compressor receives a refrigerant compression demand
signal from the air conditioning
amplifier. Based on this signal, the compressor changes the degree of
r ...
Multiplex communication circuit
Description
The air conditioning amplifier communicates data with the ecm and combination
meter through the can
communication system.
Wiring diagram
Inspection procedure
Check dt ...
Other materials:
Unmatched encryption code
Description
This dtc is output when a key with an incomplete key code is inserted into
the ignition key cylinder.
Inspection procedure
Reregister key
Clear the dtc (see page ei-18).
Reregister the key code with the transponder key ecu
(see page ei-5)
Check that the engine ...
Diagnosis system
Check dlc3
Check the dlc3:
the power steering ecu uses can (iso11898-1)
and iso9141-2 for communication protocol. The
terminal arrangement of the dlc3 complies with
sae j1962 and matches the iso9141-2 format.
Notice:
*: Before measuring the resistance, leave the
vehicle ...
On-vehicle inspection
Check accelerator pedal rod
Check the voltage.
Connect the intelligent tester to the dlc3.
Turn the ignition switch on
Turn the intelligent tester on.
Select the menu items: diagnosis /
enhanced obd ii / data list / all /
accel pos #1, accel pos #2.
Operate the acceler ...
