The monitor will not run unless:
Check the readiness monitor status displayed on the tester.
If the status does not switch to compl (complete), extend the driving time.
The monitor will not run unless:
Hint:
Do not start the engine until checking readiness monitor status. If the engine is started, the step described above must be repeated.
If the status does not switch to compl (complete), restart the engine, make sure that the preconditions have been met, and then perform the monitor conditions again.
Horn system
Parts location
System diagram
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected area" column of
the table. Check each symptom by c ...
Radio operation
Select “am” or “fm” on the audio source selection screen to
begin listening to the radio.
Audio control screen
Pressing the “audio” button displays the audio control screen from
any screens of the selected source.
Audio source selection screen
appears
Preset stations
Scanni ...
Removal
Table of bolt, screw and nut
Hint:
All bolts, screws and nuts relevant to installing and
removing the instrument panel are shown along with
their alphabet codes in the table below.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconne ...