Toyota RAV4 Service Manual: Center power outlet socket
Components
Removal
- Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove no. 1 Console upper panel garnish (see page ip-17)
- Remove no. 2 Console upper panel garnish (see page ip-18)
- Remove shift lever knob sub-assembly
- Remove upper console panel sub-assembly (see page ip-18)
- Remove upper rear console panel subassembly (see page ip-19)
- Remove center power outlet socket assembly
- Rotate the socket to disengage the notch.
- Pull out the socket halfway and rotate the socket until its protrusion is aligned with the groove of the cover.
- Remove the socket from the cover.
Installation
- Install center power outlet socket assembly
- Align the protrusion on the backside of the socket with the groove of the cover. Then push the socket into the cover.
- Install upper rear console panel subassembly (see page ip-27)
- Install upper console panel sub-assembly (see page ip-27)
- Install shift lever knob sub-assembly
- Install no. 2 Console upper panel garnish (see page ip-28)
- Install no. 1 Console upper panel garnish (see page ip-28)
- Connect cable to negative battery terminal
Power outlet socket
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Center power outlet socket (for ac power supply)
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Other materials:
Theft deterrent system
Engine immobilizer system
The vehicle’s keys have built-in transponder chips that prevent
the engine from starting if a key has not been previously registered
in the vehicle’s on-board computer.
Never leave the keys inside the vehicle when you leave the vehicle.
This system is designed to ...
Solar sensor circuit (driver side)
Description
The solar sensor, which is installed on the upper side of the instrument
panel, detects sunlight and
controls the air conditioning auto mode. The output voltage from the solar
sensor varies in accordance
with the amount of sunlight. When the sunlight increases, the output volt ...
Reassembly
Hint:
Thoroughly clean all parts to be assembled.
Before installing the parts, apply fresh engine oil to all
sliding and rotating surfaces.
Replace oil seals with new ones.
Install valve stem oil seal
Using sst, push in a new oil seal.
Sst 09201-41020
Hint:
The int ...
