Toyota RAV4 Service Manual: Check and replace ecu
Notice:
- The connector should not be disconnected from the ecu. Perform the inspection from the backside of the connector on the wire harness side.
- When no measuring condition is specified, perform the inspection with the engine stopped and the ignition switch on.
- Check that the connectors are fully seated. Check for loose, corroded or broken wires.
- First, check the ecu ground circuit. If it is faulty,
repair it. If it is normal, the ecu could be faulty.
Temporarily replace the ecu with a normally functioning one and check if the problem symptoms occur. If the problem symptoms disappear, replace the original ecu.
- Measure the resistance between the ecu
ground terminal and body ground.
Standard resistance: Below 1 ù
- Disconnect the ecu connector. Check the ground terminal on the ecu side and wire harness side for bending, corrosion or foreign matter. Lastly, check the contact pressure of the female terminals.
Check for short circuit
If the wire harness is ground shorted (fig. 5), Locate
the section by conducting a resistance check with
the body ground (below).
Check the resistance with the body ground.
Disconne ...
Terms
...
Other materials:
Yaw rate sensor communication stop mode
Description
Wiring diagram
Inspection procedure
Notice:
Turn the ignition switch off before measuring the resistances of the
main wire and the branch
wire.
After the ignition switch is turned off, check that the key reminder
warning system and light
reminder warning system ...
Evaporative emission system reference orifice
Dtc summary
Hint:
The reference orifice is located inside the canister pump module.
Description
The description can be found in the evap (evaporative emission) system (see
page es-335).
Inspection procedure
Refer to the evap system (see page es-340).
Monitor description
5 Hours* af ...
Cleaning and protecting
the vehicle interior
The following procedures will help protect your vehicle’s interior
and keep it in top condition:
Protecting the vehicle interior
Remove dirt and dust using a vacuum cleaner. Wipe dirty surfaces
with a cloth dampened with lukewarm water.
Cleaning the leather areas
Remove dirt and dust usin ...
