Standard resistance (fig. 2)
Hint:
Measure the resistance while lightly shaking the wire harness vertically and horizontally.
If the results match the examples above, an open circuit exists between terminal 1 of connector a and terminal 1 of connector c.
Standard resistance (fig. 3)
If the results match the examples
above, an
open circuit exists between terminal 1 of
connector b2 and terminal 1 of connector c.
With each connector still connected, measure the voltage between the body ground and these terminals (in this order): 1) terminal 1 of connector a, 2) terminal 1 of connector b, and 3) terminal 1 of connector c.
Standard voltage (fig. 4)
If the results match the examples
above, an
open circuit exists in the wire harness between
terminal 1 of connector b and terminal 1 of
connector c.
Front seat cushion heater
Inspection
Inspect front seat cushion heater
assembly lh
Measure the resistance of the seat cushion heater.
Standard resistance
If the result is not as specified, replace the seat
cushion heater assembly.
Heat the thermostat with a light.
Measure the resistance of the sea ...
Precaution
Caution:
Replace the faulty parts of the seat belt systems (outer
belt, inner belt, bolts, nuts, adjustable shoulder anchor,
tether anchor hardware and other related parts). When
inspecting a vehicle that was in a collision, be sure to
check all of the seat belt systems regardless of whethe ...
Control module communication bus off
Description
Inspection procedure
The skid control ecu inputs the signals from the ecm, steering angle sensor,
and yaw rate and
acceleration sensor via can communication system.
Check harness and connector (momentary interruption)
Using the data list of the intelligent test ...