Standard resistance (fig. 6)
Hint:
Measure the resistance while lightly shaking the wire harness vertically and horizontally.
If the results match the examples above, a short circuit exists between terminal 1 of connector a and terminal 1 of connector c.
Standard resistance (fig. 7)
If the results match the examples
above, a short
circuit exists between terminal 1 of connector b2
and terminal 1 of connector c.
If the results match the examples above, a short circuit exists between terminal 1 of connector b2 and terminal 1 of connector c.
Rear seats
Adjustment procedure
Pull up the lever. Then lean back to the desired angle and release the
lever.
When a person sits in the rear center position, align all seatbacks at the
same angle.
Folding down the rear seatbacks
Before folding down the rear seatbacks
Stow the rear center seat bel ...
Using the radio
Power
Volume
Adjusting the frequency
Scanning for receivable stations
Am/fm mode button
Station selectors
Seeking the frequency
Displaying text message
Setting station presets
Search for the desired stations by turning the ¢Â§tune¢escroll¢¸
knob or ...
Solenoid circuit
Description
This solenoid is turned on in accordance with signals from the skid control
ecu and controls the pressure
on the wheel cylinders to control the braking force.
The solenoid and solenoid relay are built into the abs and traction actuator.
Hint:
Dtcs c0226/21, c0236/22, c02 ...