Toyota RAV4 Service Manual: Child restraint seat tether anchor
Components
Removal
- Remove child restraint seat tether anchor cover
- Using a screwdriver, detach the 4 claws and remove the cover.
Hint:
Tape the screwdriver tip before use.
- Remove roof headlining assembly
Hint:
It is not necessary to completely remove the roof headlining. Slightly lower the rear section of the roof headlining.
- Partially remove the roof headlining (see page ir- 26).
- Remove child restraint seat tether anchor bracket
- Remove the bolt and bracket.
- Remove child restraint seat protector
Installation
- Install child restraint seat protector
- Install child restraint seat tether anchor bracket
- Align the claws with the positioning holes, and install
the bracket with the bolt.
Torque: 42 n*m (428 kgf*cm, 31 ft.*Lbf)
- Install roof headlining assembly
- Install the roof headlining (see page ir-49).
- Install child restraint seat tether anchor cover
- Install the cover with the 4 claws.
Rear center seat outer belt assembly
Components
Removal
Caution:
Wait at least 90 seconds after disconnecting the cable
from the negative (-) battery terminal to prevent airbag
and seat be ...
Sliding roof
...
Other materials:
Solar sensor circuit (passenger side)
Description
The solar sensor, which is installed on the upper side of the instrument
panel, detects sunlight and
controls the air conditioning auto mode. The output voltage from the solar
sensor varies in accordance
with the amount of sunlight. When the sunlight increases, the output volt ...
Check for intermittent problems
Hint:
Inspect the vehicle's ecm using check mode. Intermittent
problems are easier to detect with the intelligent tester when
the ecm is in check mode. In check mode, the ecm uses 1
trip detection logic, which is more sensitive to malfunctions
than normal mode (default), which uses 2 trip detec ...
Receiver error
Description
Wiring diagram
Inspection procedure
Notice:
It is necessary to register an id code after replacing the tire pressure
warning valve abd
transmitter and/or the tire pressure warning ecu (see page tw-9).
Hint:
Set the tire pressure to the specified value.
Standard pres ...
