Toyota RAV4 Service Manual: Components

Knock sensor

...

Removal

Discharge fuel system pressure (see page fu-9) Drain coolant (see page co-6) Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the c ...

Other materials:

Skid control sensor (for 2wd)
Components Removal Hint: Use the same procedures for the lh side and rh side. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery termin ...

Handling of hose clamps
Before removing the hose, check the clamp position so that it can be reinstalled in the same position. Replace any deformed or dented clamps with new ones. When reusing a hose, attach the clamp on the clamp track portion of the hose. For a spring type clamp, you may want to spread ...

Dtc check / clear
Check dtc Connect the intelligent tester (with can vim) to the dlc3. Turn the ignition switch on and turn the intelligent tester on. Read the dtc by following the prompts on the tester screen. Hint: Refer to the intelligent tester operator's manual for further details. ...