Toyota RAV4 Service Manual: Compressor lock sensor circuit
Description
This sensor sends 1 pulse per engine revolution to the air conditioning amplifier. If the ratio of the compressor speed divided by the engine speed is smaller than a predetermined value, the air conditioning amplifier turns the compressor off, and the indicator blinks at approximately 1 second intervals.
Wiring diagram
Inspection procedure
- Check air conditioning amplifier (lock signal)
- Remove the air conditioning amplifier with its connectors still connected.
- Check the waveform of the amplifier connector.
Ok:
waveform is as shown in the illustration.
- Inspect compressor lock sensor
- Disconnect the b47 compressor lock sensor connector.
- Measure the resistance of the sensor.
Standard resistance 
- Check wire harness (compressor lock sensor - air conditioning amplifier)
- Disconnect the b47 compressor lock sensor connector.
- Disconnect the e36 amplifier connector.
- Measure the resistance of the wire harness side connectors.
Standard resistance 
Replace air conditioning amplifier
Evaporator temperature sensor circuit
Description
The no. 1 Cooler thermistor (evaporator temperature sensor) is installed on
the evaporator in the air
conditioning unit to detect the temperature of the cooled air that has passed ...
Pressure sensor circuit
Description
This dtc is output when the refrigerant pressure is either extremely low
(0.19 Mpa [2.0 Kgf/cm2, 28 psi]
or less) or extremely high (3.14 Mpa [32.0 Kgf/cm2, 455 psi] or more). The ...
Other materials:
Multiplex communication circuit
Description
The air conditioning amplifier communicates data with the ecm and combination
meter through the can
communication system.
Wiring diagram
Inspection procedure
Check dtc
Clear the dtc (see page ac-127).
Read the dtc (see page ac-127).
Result
Go to can ...
Removal (2005/11-2006/01)
Remove front wheel
Drain automatic transaxle fluid
Drain the automatic transaxle fluid for u140f (see
page ax-147).
Drain the automatic transaxle fluid for u241e (see
page ax-146).
Remove front axle hub nut (see page ah-6)
Disconnect front speed sensor lh
Disconnect th ...
The rear cross traffic
alert function
The areas that vehicles can be detected in are outlined below.
The range of the detection area
extends to:
Approximately 11.5 Ft. (3.5 M)
from the side of the vehicle
The first 1.6 Ft. (0.5 M) from the
side of the vehicle is not in the
detection area
Approximately 9.8 Ft. (3 M) fr ...
