Description
In this circuit, the compressor receives a refrigerant compression demand signal from the air conditioning amplifier. Based on this signal, the compressor changes the degree of refrigerant compression.
Wiring diagram
Inspection procedure
Ok: the display is as specified in the normal condition column.
Standard resistance
Standard resistance
Standard resistance
Replace air conditioning amplifier
Direct clutch
Components
Disassembly
Inspect pack clearance of direct clutch
(see page ax-234)
Remove direct multiple disc clutch disc
Using a screwdriver, pry out the snap ring from the
direct clutch drum.
Remove the flange, 3 discs and 3 plates from the
direct clutch drum.
...
Master cylinder pressure sensor malfunction
Description
The master cylinder pressure sensor is connected to the skid control ecu in
the abs and traction
actuator.
Dtc c1281/81 can be detected when the master cylinder pressure sensor sends a
master cylinder
pressure signal or test mode ends. Dtc c1281/81 is output only in test mo ...
Installation
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
When replacing the clip, heat the clip and body using a
heat light.
Standard heating temperature
Notice:
Do not heat the clip and vehicle body excessively.
Replace roof dri ...