Description
In this circuit, the compressor receives a refrigerant compression demand signal from the air conditioning amplifier. Based on this signal, the compressor changes the degree of refrigerant compression.
Hint:
*: Compressor and pulley for 2az-fe, compressor and magnetic clutch for 2gr-fe
Wiring diagram
Inspection procedure
Ok: the display is as specified in the normal condition column.
Standard resistance
Standard resistance
Standard resistance
Replace air conditioning amplifier
Installation (2005/11-2006/01)
Install front drive shaft assembly lh
Coat the spline of the inboard joint shaft with gear
oil.
Using a brass bar and hammer, align the shaft
splines in the drive shaft.
Notice:
Set the snap ring with the opening side facing
downwards.
Be careful not to damage the oil s ...
Sliding roof control switch circuit
Description
If either the sliding function or tilt function does not operate, there may
be a malfunction in the sliding roof
control switch circuit.
Wiring diagram
Inspection procedure
Perform active test by intelligent tester (sliding roof operation)
Select the active test, use ...
Wheels
If a wheel is bent, cracked or heavily corroded, it should be
replaced. Otherwise, the tire may separate from the wheel or
cause a loss of handling control.
Wheel selection
When replacing wheels, care should be taken to ensure that they are
equivalent to those removed in load capacity, diameter ...