Toyota RAV4 (XA40) 2013-2018 Service Manual: Compressor solenoid circuit (2006/01- )
Description
In this circuit, the compressor receives a refrigerant compression demand signal from the air conditioning amplifier. Based on this signal, the compressor changes the degree of refrigerant compression.
Hint:
*: Compressor and pulley for 2az-fe, compressor and magnetic clutch for 2gr-fe
Wiring diagram
Inspection procedure
- Read value of intelligent tester (reg ctrl currnt)
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch on and turn the intelligent tester main switch on.
- Select the items below in the data list, and read the value displayed on the intelligent tester.
Ok: the display is as specified in the normal condition column.
- Inspect a/c compressor
- Disconnect the a/c compressor connector.
- Measure the resistance of the connector.
Standard resistance
- Check wire harness (a/c compressor - air conditioning amplifier)
- Disconnect the b23 a/c compressor connector.
- Disconnect the e36 amplifier connector.
- Measure the resistance of the wire harness side connectors.
Standard resistance 
- Check wire harness (a/c compressor - body ground)
- Disconnect the b23 a/c compressor connector.
- Measure the resistance of the wire harness side connector.
Standard resistance 
Replace air conditioning amplifier
Compressor solenoid circuit (2005/11-2006/01)
Description
In this circuit, the compressor receives a refrigerant compression demand
signal from the air conditioning
amplifier. Based on this signal, the compressor changes the degree of
r ...
Multiplex communication circuit
Description
The air conditioning amplifier communicates data with the ecm and combination
meter through the can
communication system.
Wiring diagram
Inspection procedure
Check dt ...
Other materials:
Removal
Drain engine coolant (see page co-6)
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove air cleaner cap (see page es-41 ...
Installation
Install fuel filler opening lid lock retainer
Install the lock retainer and turn it counterclockwise
as shown in the illustration.
Install fuel filler opening lid lock retainer
Install the cable and turn it clockwise as shown in
the illustration.
Install the fuel l ...
Terminals of ecm
Hint:
The standard normal voltage between each pair of ecm
terminals is shown in the table below. The appropriate
conditions for checking each pair of terminals are also
indicated. The result of checks should be compared with the
standard normal voltage for that pair of terminals, displayed ...
