Toyota RAV4 Service Manual: Control module communication bus off
Description
The power steering ecu receives signals from the ecm and the skid control ecu
via the can
communication system.
Hint:
- When 2 or more dtcs starting with [u] are output simultaneously, inspect the connectors and wire harness of each ecu.
- If dtc u0105/41 is output, first erase the dtcs. Then turn the ignition switch from off to on. If dtc u0105/41 is not output again, there is no malfunction.
Wiring diagram
Inspection procedure
- Reconfirm dtc
- Check for dtc.
Ok: dtc is not output.
Go to can communication system
Assist map number un-writing
Description
The power steering ecu outputs this dtc when it determines that the assist
map is not written in the
ecu.
Hint:
The assist map data is written in the power steering ecu to contro ...
Eps warning light circuit
Description
If the power steering ecu detects a malfunction, the p/s warning light comes
on. At this time, the power
steering ecu stores a dtc in its memory.
Wiring diagram
Inspection proced ...
Other materials:
Disassembly
Remove generator pulley with clutch
Remove the cap from the pulley.
Using a screwdriver, puncture the center of the
cap and pry it off.
Notice:
Do not reuse the cap.
Install sst to the pulley and vise as shown in the
illustration.
Sst 09820-63020
Mount sst (a) i ...
Reassembly
Install cooler (solar sensor) thermistor
(for automatic air conditioning system)
Install automatic light control sensor
(for automatic light control system)
Install front passenger airbag assembly
(see page rs-351)
Install no. 2 Instrument panel register
assembly
Install no. 1 Ins ...
Installation
Install accelerator pedal rod
Install the accelerator pedal rod with the 2 bolts.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*Lbf)
Connect the accelerator pedal position sensor
connector.
Connect cable to negative battery terminal
...
