Toyota RAV4 Service Manual: Cooling fan motor
On-vehicle inspection
- Inspect no. 1 Cooling fan motor
- Disconnect the no. 1 Fan connector.
- Connect the battery and ammeter to the no. 1 Fan motor connector.
- Check that the no. 1 Fan rotates smoothly, and then check the reading on the ammeter.
Standard amperage 
Hint:
Refer to the illustration for the indication mark location.
If the result is not as specified, replace the no. 1 Cooling fan motor.
- Reconnect the no. 1 Fan motor connector.
- Inspect no. 2 Cooling fan motor
- Disconnect the no. 2 Fan connector.
- Connect the battery and ammeter to the no. 2 Fan motor connector.
- Check that the no. 2 Fan rotates smoothly, and then check the reading on the ammeter.
Standard amperage 
Hint:
Refer to the illustration for the indication mark location.
If the result is not as specified, replace the no. 2 Cooling fan motor.
- Reconnect the no. 2 Fan motor connector.
Removal
- Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove radiator assembly
- Remove the radiator (see page co-29).
Disassembly
- Remove fan
- Remove the 2 nuts and 2 fans.
- Remove no. 1 Cooling fan motor
- Remove the 3 screws and fan motor.
- Remove no. 2 Cooling fan motor
- Remove the 3 screws and fan motor.
Reassembly
- Install no. 2 Cooling fan motor
- Install the fan motor with the 3 screws.
Torque: 3.9 N*m (40 kgf*cm, 35 in.*Lbf)
- Install no. 1 Cooling fan motor
- Install the fan motor with the 3 screws.
Torque: 3.9 N*m (40 kgf*cm, 35 in.*Lbf)
- Install fan
- Install the 2 fans with the 2 nuts.
Torque: 6.3 N*m (64 kgf*cm, 55 in.*Lbf)
- Check the fan motor operation.
Installation
- Install radiator assembly
- Install the radiator (see page co-32).
- Connect cable to negative battery terminal
- Add engine coolant (see page co-6)
- Add engine coolant (see page co-6)
Thermostat
Components
Removal
Remove no. 1 Engine under cover
Drain engine coolant (see page co-6)
Remove radiator support opening cover
Disconnect no. 2 Radiator hose
Remove water inlet
R ...
Cooling fan relay
On-vehicle inspection
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airb ...
Other materials:
Installation with latch system
Adjust the seatback to the 8th
lock position from the fully
reclined position.
Fully reclined position
8Th lock position
If your child restraint system interferes with a head restraint and
cannot be installed properly, install the child restraint system after
removing the hea ...
Light control switch circuit
Description
This circuit detects the state of the headlight dimmer switch.
Wiring diagram
Inspection procedure
Read value of intelligent tester (main body ecu)
Connect the intelligent tester to the dlc3.
Turn the ignition switch on and press the intelligent
tester main switch on ...
Bluetooth® phone
settings
You can adjust the hands-free system to your desired settings.
“Phone/message settings” screen
To display the screen shown below, press the “setup” button, and
select “phone” on the “setup” screen.
Set the phone connection
Setting the sound
Contact/call history settings
...
