Toyota RAV4 Service Manual: Crankshaft position sensor

Installation

Install camshaft position sensor Notice: Make sure that the o-ring is not cracked or jammed when installing it. Apply a light coat of engine oil to the o-ring of the sensor. In ...

Removal

Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt preten ...

Other materials:

Wheels
If a wheel is bent, cracked or heavily corroded, it should be replaced. Otherwise, the tire may separate from the wheel or cause a loss of handling control. Wheel selection When replacing wheels, care should be taken to ensure that they are equivalent to those removed in load capacity, diameter ...

Inspection
Inspect oil pump assembly Turn the drive gear with 2 screwdrivers and make sure it rotates smoothly. Notice: Be careful not to damage the oil seal lip. Inspect clearance of oil pump assembly Push the driven gear to one side of the body. Using a feeler gauge, measur ...

How to proceed with troubleshooting
Hint: Use these procedures to troubleshoot the engine immobiliser system. *: Use the intelligent tester. Vehicle brought to workshop Inspect battery voltage Standard voltage: 11 to 14 v If the voltage is below 11 v, recharge or replace the battery before proceeding. cran ...