Toyota RAV4 (XA40) 2013-2018 Service Manual: Cruise control
- Cruise control system
- Precaution
- Parts location
- How to proceed with troubleshooting
- Road test
- Registration
- Problem symptoms table
- Terminals of ecm
- Diagnosis system
- Dtc check / clear
- Fail-safe chart
- Data list / active tes
- Diagnostic trouble code chart
- Cruise control system cruise control main switch
Brk relay
On-vehicle inspection
Inspect brk relay
Remove the brk relay from the engine room no. 1
Relay block.
Measure the resistance of the relay.
Standard resistance
If the result is no ...
Other materials:
RCTA function
â– Operation of the RCTA
function
The RCTA function uses rear
side radar sensors to detect
vehicles approaching from the right or left at the rear of the
vehicle and alerts the driver of
the presence of such vehicles
by flashing the outside rear view
mirror indicators and sounding a
buzzer.
Appr ...
Calibration
Description
After replacing components relating to the vsc or
performing "front wheel alignment adjustment",
clear and read the sensor calibration data.
Follow the chart to perform calibration.
Clear zero point calibration data (when using
intelligent tester)
...
AHB (Automatic High
Beam)
The Automatic High Beam
uses an in-vehicle front
camera to assess the brightness
of streetlights, the
lights of vehicles ahead etc.,
and automatically turns the
high beams on or off as necessary.
WARNING
â– Limitations of the Automatic
High Beam
Do not overly rely on the Automatic
High Beam. Always ...
