Description
This circuit sends signals to the ecm depending on the cruise control switch condition. The battery supplies positive (+) battery voltage to the cruise control switch. Then terminal ccs of the ecm receives the voltage according to the switch condition.
Wiring diagram
Inspection procedure
Ok: when cruise control switch operation is performed, the results will be same as above.
Standard resistance
Standard resistance
Standard resistance
Proceed to next circuit inspection shown in problem symptoms table
System description
Description
The eps (electronic power steering) system generates
torque through the operation of the motor and the
reduction gear installed on the column shaft in order to
assist steering effort.
The power steering ecu determines directions and the
amount of assisting power in accordanc ...
If the electronic key does
not operate properly
(vehicles with a
smart key system)
If communication between the electronic key and vehicle is
interrupted („_p. 107) Or the electronic key cannot be used
because the battery is depleted, the smart key system and wireless
remote control cannot be used. In such cases, the doors
can be opened and the engine can be started by follo ...
Adjusting the position of and opening and closing the air outlets
Front center outlets
Direct air flow to the left or
right, up or down.
Turn the knobs to open or
close the vents.
Turn the knob to open or
close the vent for rear seat
occupants.
М
Direct air flow to the left or right,
up or down.
Open the vent.
Close the vent.
...