Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Cruise control system

Cruise control
...

Precaution
Handling precaution for cruise control system Turn the cruise control main switch off when not using the cruise control system. Be careful as the vehicle speed increases when driving do ...

Other materials:

RCTA (Rear Cross Traffic Alert) function
The RCTA function uses the BSM rear side radar sensors installed behind the rear bumper. This function is intended to assist the driver in checking areas that are not easily visible when backing up. WARNING â– Cautions regarding the use of the system The driver is solely responsible for safe driving ...

Removal
Discharge fuel system pressure (see page fu-9) Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove hood sub-assembly ( ...

Reassembly (2006/01- )
Install front drive shaft bearing (for rh) Install the bearing bracket snap ring to the inboard shaft. Using sst and a press, press in the drive shaft bearing to the inboard joint rh. Sst 09527-10011, 09710-04081 Notice: The bearing should be installed completely. Usi ...

© 2011-2026 Copyright www.trav4.net