Components
Removal
Caution:
Be sure to read the precautionary notices concerning the srs airbag system before servicing it (see page rs-1).
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Inspection
Standard resistance
If the result is not as specified, replace the switch assembly.
Tc and cg terminal circuit
Description
Connecting terminals tc and cg of the dlc3 enables dtcs to be read through blinking patterns of the combination meter's cruise main indicator light.
Hint:
When a warning light of the combination meter blinks continuously, terminal tc of the dlc3 or an ecm may have a ground short.
Wiring diagram
Inspection procedure
Standard resistance
Replace ecm
Installation
Torque: 1.7 To 3.0 N*m (17.34 To 30.60 Kgf*cm, 15.04 To 26.55 In.*Lbf)
Dtc check / clear
Check dtc
Dtcs which are stored in the ecm can be displayed
with the intelligent tester.
The intelligent tester can display pending dtcs and
current dtcs. Some dtcs are not stored unless a
malfunction is detected in consecutive driving
cycles. When a malfunction is detected ...
Communication
Description
The skid control ecu sends signals such as cruise control cancel demand
signals and brake operation
demand from ecm response signals to the ecm when the cruise control system is in
operation.
Inspection procedure
Hint:
This circuit uses can communication. Therefore, if t ...
Head restraints
Head restraints are provided for all seats.
Front seats
Up
Pull the head restraints up.
Down
Push the head restraint down while
pressing the lock release button.
Rear seats
Up
Pull the head restraints up.
Down
Push the head restraint down while
pressing the lock rel ...