Toyota RAV4 (XA40) 2013-2018 Owners Manual: Customizing the startup and screen off images (if equipped)
An image can be copied from a usb memory and used as the startup and screen off images.
When the engine switch is in the “acc” or “on” position (vehicles without a smart key system) or accessory or ignition on mode (vehicles with a smart key system), the initial screen will be displayed.
When “screen off” on the “setup” screen is selected, the screen is turned off and the desired screen off image that is set is displayed.
Transferring images
- Open the cover and connect a usb memory.
Turn on the power of the usb memory if it is not turned on.
- Press the “menu” button.
- Select “setup”.
- Select “general”.
- Select “customize startup image” or “customize screen off image”.
- Select “transfer”.
- Select “yes”.
- When saving the images to a usb, name the folder that the startup image is saved to “startupimage” and name the folder that the screen off image is saved to “displayoffimage”. If these folder names are not used, the audio system cannot download the images. (The folder names are case sensitive.)
- The compatible file extensions are jpg and jpeg.
- Image files of 5 mb or less can be transferred.
- Up to 3 images can be transferred to the audio system.
Setting the startup images
- Display the “general settings” screen.
- Select “customize startup image”.
- Select the desired image.
- Select “ok”.
Setting the screen off images
- Display the “general settings” screen.
- Select “customize screen off image”.
- Select the desired image.
- Select “ok”.
Deleting transferred images
- Display the “general settings” screen.
- Select “customize startup image” or “customize screen off image”.
- Select “delete all”.
- Select “yes”.
Delete personal data
- Select “delete personal data” on the “general settings” screen.
- Select “delete”.
Check carefully beforehand, as data cannot be retrieved once deleted.
- A confirmation screen will be displayed. Select “yes”.
The following personal data will be deleted or changed to its default settings.
- General settings
- Audio settings
- Phone settings
Screen for general settings
Press the “setup” button.
Select “general” on the “setup”
screen.
“English”, “français” or
“español” can be selected.
On/off can be selected to
...
Audio settings
Settings are available for adjusting the radio operation, cover
art, etc.
Screen for audio settings
Press the “setup” button.
Select “audio” on the “setup” screen.
Numbe ...
Other materials:
Insufficient coolant temperature for closed loop fuel control
Description
Refer to dtc p0115 (see page es-105).
Monitor description
The resistance of the ect sensor varies in proportion to the actual ect. The
ect supplies a constant
voltage to the sensor and monitors the signal output voltage of the sensor. The
signal voltage output
varies acc ...
How to proceed with troubleshooting
Hint:
Use these procedures to troubleshoot the key reminder
warning system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage
Standard voltage:
11 to 14 v
Hint:
If the voltage is below 11 v, recharge or replace the battery
before proceedi ...
Do-it-yourself service
precautions
If you perform maintenance by yourself, be sure to follow the
correct procedure as given in these sections.
Caution
The engine compartment contains many mechanisms and fluids that may
move suddenly, become hot, or become electrically energized. To avoid death
or serious injury, obse ...
