Toyota RAV4 manuals

Toyota RAV4 Service Manual: Data list / active test

Hint:

Using the intelligent tester's data list allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the data list early in troubleshooting is one way to save time.

  1. Data list for occupant classification ecu

Toyota RAV4. Data list for occupant classification ecu


  1. Connect the intelligent tester (with can vim) to the dlc3.
  2. Turn the ignition switch on.
  3. Read the data list on the tester's screen.

Toyota RAV4. Data list / active test


Toyota RAV4. Data list / active test


Dtc check / clear
Check dtc Hint: When dtc b1650/23 is detected as a result of troubleshooting for the airbag system, troubleshoot the occupant classification system. Use the intelligent tester (with ca ...

Diagnostic trouble code chart
If a trouble code is displayed during the dtc check, check the circuit listed for the code in the table below (proceed to the page listed for that circuit). ...

Other materials:

Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove no. 1 Engine under cover Remove front fender apron rh Remove radia ...

Installation
Install no. 2 Radiator grille lower Install the radiator grille and attach the 16 claws. Install no. 1 Radiator grille lower Install the radiator grille and attach the 16 claws. Install radiator grille Install the radiator grille with the 6 claws. ...

Can communication system
Precaution Precaution Turn the ignition switch off before measuring the resistance of the main wire and the branch wire. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation. Before measuring th ...

В© 2011-2024 Copyright www.trav4.net